Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Trusted Chimney Sweep for University City Homeowners
A chimney that hasn’t been swept in a while doesn’t announce itself. It shows up as a weak draft on a cold morning, a faint smoky smell in the living room, or black flaky buildup you notice on the firebox walls. That buildup is creosote, and it’s the reason an annual sweep matters. We’re a chimney specialist, not a general handyman with a brush. Our technicians have up to 8 years of experience, and we work the entire system from the firebox floor to the chimney crown. A plain sweep is the first step; what we find during it tells you what actually needs attention. Call (855) 658-5324 to book a sweep in University City. We answer 24/7, and same-day service is often possible.
What Our Chimney Sweep Service Includes
A proper sweep is more than running a brush up the flue. It’s a look at the whole system, done in stages that tell you what shape the chimney is in before you light the first fire of the season.
Level 1 Inspection
A Level 1 inspection is the basic visual check that comes with a routine sweep. We look at the firebox, damper, flue, and the accessible parts of the exterior for obvious problems, and it’s the right call when your chimney has been swept regularly and nothing has changed. If we spot something during a Level 1 that needs a closer look, we’ll tell you and explain why before going further.

Level 2 Inspection
A Level 2 inspection goes deeper, using a camera to see inside the flue where the eye can’t reach. You need one after a chimney fire, a change in fuel type, a new appliance connection, or when you’re buying a home and don’t know the chimney’s history. We run the camera, review the footage with you, and point out exactly what the liner looks like.

Creosote Removal
Creosote is the tar-like residue left behind by burning wood, and it comes in stages from light soot to a hard, glazed layer that brushes won’t touch. Glazed creosote is the dangerous kind, and it’s a leading cause of chimney fires. We remove what brushes and rods can reach, and when the buildup is glazed we’ll explain whether a chemical treatment or HeatShield resurfacing is the right path instead of guessing.

Soot Removal
Soot is the fine, powdery carbon that coats the firebox, damper, and smoke chamber after burning. It’s less hazardous than creosote but it stains, dulls draft, and coats everything it touches when disturbed. We vacuum as we work, using sealed equipment, so the soot goes into the machine and not into your living room.
Annual Sweep
An annual sweep keeps creosote from building to a dangerous level and gives you a record of the chimney’s condition year over year. If you burn wood regularly, once a year is the baseline; heavier use means more frequent attention. We’ll tell you honestly whether you’re due now or whether the chimney can wait until next season.
Fireplace Cleaning
Fireplace cleaning covers the firebox, hearth, glass doors, and the surrounding masonry that a flue sweep alone doesn’t reach. It’s worth doing when soot and ash have built up on the firebox walls, when the hearth looks dingy, or when you’re getting a house ready to sell. We clean the whole surround so the fireplace looks and functions the way it should.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Brands We Service for Chimney Sweep
Chimney systems are built from branded components, and knowing those components matters when something drives a diagnosis. We service DuraFlex flexible liner systems and know where they wear at the joints and at the top plate, which is often where a draft problem starts. We also work with Olympia Chimney products, including the caps and components that sit at the top of the system, so we understand how those parts age and what to check during a sweep.
We work with Famco components as well, and we know the points where those assemblies tend to loosen or corrode over time. That familiarity with the brands in your chimney is part of what a specialist brings to a sweep, because the same symptoms can point to different fixes depending on what’s installed. Whether you have a DuraFlex liner, an Olympia cap, a Famco assembly, or any other make, we can help.
Signs You Need Chimney Sweep Right Now
Most chimneys give plenty of warning before they become a real problem. Here are the signs worth paying attention to.
- Creosote buildup on the firebox walls. If you can see a black, crusty or shiny layer, there’s likely more of it up the flue. Glazed creosote is the dangerous type and needs attention before the next fire.
- A smoky smell in the house when the fireplace is off. That’s often a sign of a blocked flue or a draft problem pulling air back into the room. It usually means the chimney needs a sweep and a look at the cap.
- Weak draft or smoke spilling into the room. A fire that struggles to draw or pushes smoke into the living room is telling you something is restricting airflow. A sweep and inspection will show whether it’s creosote, a nesting animal, or a damaged liner.
- A chimney fire you suspect but didn’t confirm. A loud roar, a shower of sparks, or cracked flue tiles after a fire all point to a chimney fire. Even a small one can damage the liner, and a Level 2 inspection is the way to know.
- It’s been more than a year since the last sweep. If you can’t remember the last time the chimney was cleaned, that alone is reason enough. A sweep now prevents a bigger problem later in the season.
Our Chimney Sweep Process – Step by Step
Every job follows the same sequence, so you know what’s happening and why.
- 1
We start with a conversation and a walkthrough. We ask how you use the fireplace, what fuel you burn, and whether you’ve noticed anything unusual. Then we look at the firebox, damper, and the outside of the chimney before we touch a brush.
- 2
We protect the room before we work. Drop cloths go down and a sealed vacuum runs throughout the sweep, so soot and ash stay contained. That’s the difference between a professional sweep and a messy one.
- 3
We sweep the flue and firebox. Brushes and rods sized to your flue clear the creosote and soot, and we follow up with the vacuum. We clean the smoke chamber and damper area too, not just the visible firebox.
- 4
We run a camera inspection when it’s warranted. A camera shows us the inside of the liner, the joints, and the top of the flue. We review the footage with you so you can see what we see, and there’s no mystery about what needs fixing.
- 5
We give you a written report and a straight answer. You get a clear picture of the chimney’s condition, what we found, and whether anything needs repair now or can safely wait. Nothing gets recommended without evidence you can look at yourself.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Sweep Cost in University City?
A typical chimney sweep in University City runs $150 to $300 depending on the flue length, how much creosote has built up, and whether the job includes a Level 1 inspection. A standard sweep with a visual check usually lands at the lower end, while a heavier job with glazed creosote or a fireplace cleaning pushes toward the upper end. A Level 2 inspection with camera work adds to the total, and if we find damage that needs repair, those costs are quoted separately based on the written estimate. Pricing like this is per job, and the written estimate you get before we book sets the final price.
What affects the price most is the condition of the chimney, not the size of the house. A flue that’s been swept regularly is quicker to clean than one that hasn’t been touched in years. The best way to avoid overpaying is to get a written estimate that spells out what’s included, and to ask whether the price covers just the sweep or the inspection as well. Our estimates are free, and we’ll tell you plainly if you don’t need the deeper work. Call (855) 658-5324 for an exact quote.
Chimney Sweep Near University City – Our Service Area
We serve homeowners across University City and the surrounding communities, including Harrisburg, Huntersville, Concord, and the Charlotte neighborhoods of NoDa, Plaza Midwood, Myers Park, and Elizabeth. If you’re just outside those areas, call and we’ll confirm coverage. For a nearby option, see our chimney sweep page for Harrisburg, or browse the main Chimney Sweep University City page to see everything we handle.
Serving University City, NC – Our Local Coverage Area
We serve University City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Sweep in University City
A chimney sweep is a professional cleaning of the flue, firebox, smoke chamber, and damper to remove creosote and soot. It’s not just a brush up the chimney; a proper sweep includes a visual inspection of the accessible parts of the system so you know its condition. We sweep the whole system from the firebox floor toward the crown, contain the dust with sealed equipment, and give you a written report on what we found. Call (855) 658-5324 to book yours.
A standard sweep usually takes about an hour, though a heavier job with thick creosote or a fireplace cleaning can take longer. If we add a Level 2 camera inspection, plan for a bit more time. We’ll tell you up front roughly how long your job should take based on what we see when we arrive. Call (855) 658-5324 to schedule.
A typical chimney sweep in University City runs $150 to $300, depending on the condition of the flue and whether an inspection is included. Heavier creosote buildup, a fireplace cleaning, or a Level 2 inspection adds to the total. The written estimate sets the final price, and our estimates are free. Call (855) 658-5324 for an exact quote.
Yes, we service DuraFlex liner systems and work with Olympia Chimney and Famco components as well. Knowing how these brands age tells us where to look during a sweep, whether that’s a worn joint, a top plate, or a cap that’s lost its seal. Whatever brand is in your chimney, we can help. Call (855) 658-5324 to talk through what you have.
Same-day service is often available, and the fastest way to find out is to call. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. We’re closed on Saturday, and a call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Call (855) 658-5324 and we’ll get you scheduled.
We stand behind our work with a satisfaction guarantee, and we’ll explain what’s covered on any repair before we start. If we recommend a fix, we show you the evidence behind it, and if work can safely wait, we’ll tell you that too. You won’t be pushed into anything you can’t verify. Call (855) 658-5324 with questions about a specific job.
Clear the area around the fireplace and hearth, move any furniture or decor back a few feet, and make sure we can reach the firebox and the roof access. If you have pets, it helps to keep them in another room while we work. Other than that, you don’t need to do much; we handle the drop cloths, the vacuum, and the cleanup. See our chimney sweep page for the same guidance in Huntersville. Call (855) 658-5324 to book in University City.
Schedule Your Chimney Sweep Service in University City Today
If your chimney is due for a sweep, don’t wait until the first cold night to think about it. Call (855) 658-5324 to book a chimney sweep in University City, get a straight answer on what your system needs, and a free, no-obligation estimate before anything is booked. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. For related work, see our chimney sweep page.
Written by the team at Chimney Sweep University City.